The major players involved in holding the 2019 National Safety Stand-Down to Prevent Falls in Construction will host a webinar to help would-be participants make the most of the event. Falls are the top cause of construction fatalities and account for a third of on-the-job injuries and deaths in the industry.

Dennis Mason's body was found, face down, between his truck and a crude oil tank at a well site near Kingfisher, Okla. Investigators immediately suspected he was killed by toxic vapors from the oil. But they weren't able to prove it, because state medical examiners didn't test Mason's blood for petroleum chemicals before declaring his death natural, the result of heart failure. OSHA inspectors had quickly sent word to the medical examiners that they suspected his death was related to his job hauling oil for Sunoco Logistics Partners.

According to audio taken from the cockpit voice recorder (CVR) of the cargo plane that crashed near Houston’s George Bush International Airport Feb. 23, “crew communications consistent with a loss control of the aircraft began approximately 18 seconds prior to the end of the recording.” That description from the National Transportation Safety Board’s (NTSB) Office of Research and Engineering Vehicle Recorder Division was part of a preliminary report into the crash of Atlas Air Flight 3591, which claimed the lives of the three pilots on board.

There is a network of thousands of miles of pipes underlying the frenzied oil and gas development in the Permian Basin of Texas. Nationally, more than 450,000 miles of such gathering lines snake underground from wells, and reports of death and injury have emerged from Texas to Pennsylvania.

U.S. Congressman Don Bacon’s (R-NE) efforts to help protect the nation’s workers have won him recognition from the International Safety Equipment Association (ISEA) in the form of a Legislative Leadership Award. The award was presented to Bacon on February 26.

When working in freezing temperatures, it always pays to be prepared. Whether you’re working in a year-round cold environment such as cold storage or you’re working construction in the dead of winter, knowing a few cold weather safety tips can help you remain both functional and comfortable on the job.

People who work outside or who do the heavy lifting for a living are often jealous of office workers. “They have it so easy!” you hear them say, “They never have to worry about the heat, the cold, or being injured.” While the office temperature is debatable, it is not true that desk jobs carry no risk of injury. The CDC states that in 1999, about 1 million people took time off work to recover from musculoskeletal injuries due to poor economics, costing businesses about $50 billion each year in lost wages and productivity.

The International Safety Equipment Association (ISEA) has released a new standard — ANSI/ISEA 138-2019, American National Standard for Performance and Classification for Impact Resistant Hand Protection — to improve on the impact performance of industrial gloves. The new standard builds upon the widely used ANSI/ISEA 105-2016, American National Standard for Hand Protection Classification.

The American Society of Safety Professionals (ASSP) has announced leadership changes on two ANSI/ASSP standards committees that work to advance occupational safety and health across the country. Voluntary consensus standards promote best practices and prevent worker injuries, illnesses and fatalities.

The employers of a worker killed on a light rail tunnel project in San Francisco failed to identify potential hazards and to train workers on safety procedures, according to Cal/OSHA, which has issued $65,300 in penalties in the fatality. The incident occurred last August, while employees were using heavy equipment and tools to work in and around the tunnel.